PMDG 737 NG (Legacy Version)

Situation:Flight LSZB-EKCX 579NM (FSBuild planning)PMDG 737-700, 128 passenger on board in mixed configuration 23040lbsBaggage 3902lbs (1952lbs fwd cargo, 1950 aft cargo)Cruising Altitude FL310Headwind 20ktsUsing 737NG Fuel Planner I obtained the following calculation:Trip Distance 600NMAlternate 200NMHeadwind 20kts (from ActiveSky Evolution)WCA 32NMTotal NAM 632NMPax+Cargo 26942lbsAlternate Fuel 3300lbsHolding fuel (30min) 2600lbsMin Landing Fuel 2600lbsEnroute Fuel Burn 8111lbsTaxi fuel 550 (about 7min)Total fuel at taxi 17161lbsThe problem is that at the end of the flight (5 minutes taxi 1h 40min of flight and 3 or 4 min taxi to the parking area) when I checked the fue…

Anyone have any ideas as to what kind of system you will need to run this baby--or the cost? All ready saving my pennies.Gary

I have been told by someone who works with PMDG (the person is remaing ANONYMOUS) that the NGX is ready has been for some time now. The real problem is with copyright issues inside PMDG, as a result of conflicts between preeminent members. And until this is solved they cannot and will not release the NGX. That's as much as I got told. If anyone else has ANY info, please add...

Hi all here!It is just an old thing but I want to get back on it: Everytime I switch on the panel lights of the 737NG with (CPFlight-)MCP and (FlyEngravitiy-)CDU-drivers installed the "Standby Altimeter" will black out which counts both for the 2D and 3D-panel:What can I do to recover the instrument to be usable at night?thanks a lot!Bert GronerFS MAGAZINwww.fsmagazin.de

Hi, I have put the pmdg 737ng into fsx and i find all the systems work perfectly, my only problem is the overhead, I can't click on anything on and I have to bring up the 2d cockpit panel to use it. I knew that there might be a fez bugs with fsx but i have seen on youtube and your site the 3D switches.RegardsAndrew CaryP.S. I have only put this into fsx while i am waiting for the NGX so there is no big rush.[EDIT:Just come across a problem with the 737-800/900, it will only load with the 2d cockpit.:EDIT]

I need help regarding Installation of pmdg and where I could buy the program? Please send me an email to [email protected]

It's a simple one, and one that I'm suprised I can't seem to find anywhere. I'm looking for a "Janet" repaint for the -600

HiI remember reading somewhere that there is a small program available to correct the installation path in FS9 for PMDG B737 aircraft. This corrects the problem where the sliders will not work in the load manager. Can anyone help by reminding me where to find this? Thanks.

I recently had to reinstall FS9 and all models of PMDG 737NG...600/700/800/900 due to change over to 64-bit system...I went into the PMDG key command menu and set tasks as instructed by Opencockpits support but I can't get Auto Throttle Switch and the Speed button to engage...not even if I use the mouse and try to click on screen...goes green for less than a second and shuts back off...checked for duplicate key commands in FS9 but found nothing...can anybody out there help me?...Thanks in advance!Steven LeingangWin XP Pro/SP 2, 64-bit, GIGABYTE GA-EX38-DS4 775 X38 RT, Core2 Quad, CPU Q9300 2.50GHz, MEM 2Gx2|GSK F2-8500CL5D-4GBPK, Nvidia GeForce GTX 260 Maxcore 55 OC, 850W…

Hi,In the Paint kit of PMDG737 there is a file named "pmdg_x00_full_left" & "pmdg_x00_full_right". what is the function of it? In which format do I save it? After painting this particular file do I still need to paint "PMDG_x00_FUSE_RIGHT_T" & "PMDG_x00_FUSE_LEFT_T".I am really new to these kind of things, so any help would be appreciated.And if somebody can paint me the PMDG737-900 aircraft in PIA latest(2010) livery I would be very grateful.The Picture can be seen here: http://www.planepictures.net/netshow.php?id=1004334 .Thanks in advance,Uzair Aziz

Hi PMDG teamI believe that today is Friday, promises promises is ... ... where's the 737 NGX I (and the rest) are still waiting .. but the patience is running out. (joke there) .. Seriously, it comes today or not?.Sincerely,waw

G'day Guys,Recently upgraded my graphics card from Nvidia GeForce 7950 GX2 to GTX460 1GB with remarkable results excellent frame rates and smoother images.I only have Windows XP, CPU Core 2 Duo E8500 3.16GHz with PSU of 620W still the results are excellent.My interests lie with FS9 as the base sim and the PMDG 737NG model. Resolution 1280x1024x32 in FS9, the monitor and in the Nvidia GTX460 video card. The resolution of 1280x1024x32 was the same with the 7950 GX2 card installed.Now for the question, the B737NG main instrument panel and in particular the EICAS EGT gauge(s). Prior to changing over the video card I had three digit read out for the EGT gauges which is how it …

Hi, I'm new user of the AVSIM forum. My name is Andrea Nardi.I noticed that there are some strange behaviours reguarding the fuel quantity related to the eventual engine failure.PMDG 737-700. I wanted to see the behaviour of the engines in case one wing tank became empty and the other one still had enough fuel in it. I tried to set a certein quantity of fuel (2000kg) in one wing tank and I left the other with just a few kgs of fuel (let say 20kg) and the center tank empty with its pumps off.The pumps of the wing tanks are obviously ON but the CROSS FEED is closed. After a few seconds (when the tank with a very low quantity of fuel is completely empty) both the engines sto…

Good evening.I just installed once again my PMDG 737-600/700 and recognized, that there are no SID/STAR included in my FMC.Example: I want to fly from LSZH to LIRF but the FMC just have one rumway for both airports.I searched for a solution for my problem in many forums where I found some imformation about downloading files from navdata.at and so on, but it doens't work!At first, I downloaded the SID/STAR file for LSZH and LIRF for "All PMDG Products" from navdata.at and put them into ...fs9/pmdg/sidstars but than i din't had any runways or sid/star at all anymore. Than I read somewhere else, that I should install the ALL IN ONE 767PIC from navdata.at and put them into f…

Can someone tell me what the recommended landing speed for the 737-900 is under normal circumstances? I can't find it in any of the manuals. To date I tend to reduce speed from 250k to 160k whilst dropping to 25 of flap immediately before picking up the localiser and then reducing to 130 (still with 25 flap) prior to picking up the glideslope. The aircraft seems quite stable but I wonder how far this tallies with the authorised speed.Jim

Good evening all,I just purchased this NGX 737 800/900 for FS9 this afternoon. I tried some short hops this evening, but ran in to a couple issues. One of them was kind of addressed here, but I was unable to see if it was resolved.- I noticed that the auto brake control doesn't work. If I select RTO, it doesn't return to off once I pull the landing gear in. I don't know if this is the way it is supposed to work. I also noticed that when I landed, a light saying the brakes had de-activated. Again, I haven't seen this happen on any other plane - so I don't know if this is actually more realistic or not.- I also saw that as soon as I put the flaps down, I had the red dotted …

Hi :)Will this run the NGX?Windows 7 64Intel Core i7 q720 1.60 GHzGeForce GT 230M

Hi everyoneI'd like to buy the new sets of manuals for the boeing 737 ngx and my question is: how close to the real manuals they are? take off profile landing etc...are like the real manuals? Thank you

Is anyone using FDSFX with this aircraft? If so, what do you think? Do you have coordinates for the gauge? Thanks!

Hi, I'm Neil Johnson and sorry if I started a new thread after solving another problem so soon :blush:I just made a fresh reinstall of FSUIPC + FS9 + PMDG(with it's service pack 1) and all the lights come on except for the taxi and landing lights. (all models of the NG)I am running REX FS2004, and I am not sure if that can contribute to the problem, but I highly doubt it.Is there a fix to this? Thanks in advance!

Hello avsim, the PMDG 737NG aircraft is a great aircraft, but I have one problem.At any random occasion, my radios get stuck and I cannot change the frequencies of my NAV or COM radios. They are stuck no matter how many times i click on the dials. I'm currently using the 737-900 and I have updated to service pack 1anyone know a fix to this? I'd really appreciate it!thanks!

well hello, I got a qustion about the new 737 NGX, how would the MCP interface bee would it be like the 747 or the J41. The reason i ask is that now i have been working whit both and the 747 i had to give up on to get the display of my goflight to show the same as in the add-on. but the J41 i got display working as there was L.vars like L:HDGBugwhich is very use full. and other to the buttons and so. As there isent much fun in having hardware that cant comunicate whit the add-on best regards LN

I have the 737-6+700 and have no problems flying , I just installed the 800+900 ,the flight goes well but after i land and use reverse thrust ,when i push the throttle foreward to come out of reverse FS-9 freezes ,the engine sound goes up + down but the sim is frozen + i have to shut the computer down, I have windows XP + FS-9 ,Also when i put a freeware panel in it dosent do this,does anyone know what causes this to happen .

Hi Guys,Just did a short flight and did engine shutdown and now am wanting to fly again, however i'm not able to start engine 2. No.1 started no problem, so what do I need to do.Help would be appriecated.ThanksAndy

I've purchased the complete Chief Pilot's documentation set for the 737NGX, and have used the 3 posters for display in my cockpit room. But I would also like a set to mount on boards for portable use, as in my office. Is it possible to purchase just the posters, separately? I ask, of course, as a purchaser of the full bundle already.Thanks,Pete Dowson