MS FSX | FSX-SE Forum
Subforums
96377 topics in this forum
-
I am used to setting my fuel up easily in other adding like PMDG,Leveld767 etc. I have no idea though how to understand the load manager in the 757 though. I read through the manual and it had graphs but was confusing to me. I only needed 60,000 lbs fuel but it doesn’t give me that option. Shows cargo and forward,mid and aft economy. Like other Addison’s I could move the slider to the correct fuel but this doesn’t have that. I just watch the zero fuel weight move which I’m unfamiliar with. Can someone help me?
-
- 1 reply
- 2.2k views
-
-
So I have this problem in the Thomas Ruth A320 VC, where when I look down, or to the right, like this, the VC shows. But when I look forward, it disappears. If anybody knows how to fix it would be greatly appreciated 🙂
-
- 3 replies
- 1.8k views
-
-
Please help! Almost every time I log into fsx and goes in my plane (pmdg 737) the plane loads in 20 secs but after that the back wheels goes down just like I have just landed even though I am at gate standing still. But after the back wheels goes down my nose wheel goes down but the nose wheel goes under the ground and the aircraft is all glitched out. What is the reason for this and what should i do? Thanks
-
- 5 replies
- 1.9k views
-
-
so when FSX:SE is loading up, i get this error message as well as this error message. now if i click on "no" to both of them. Then Flight Sim proceeds to start up no problem, willy nilly. But if i say yes to either/both of them. it then says "The module "X.dll" has not been tested for compatability with the FSX version you have installed"......"If you run the module, it may cause problems or a crash. Run the module now?" And if i click on Don't run on both of the addons that are causing the pop-up. FSX then continues to run with no-issue, and no noticable disturbance. But if i click on "run" FSX:SE will then proceed to promptly crash. Do any of yall's have any int…
-
- 0 replies
- 599 views
-
-
While taking off with the PMDG 777-200 I reach v1 and vr in a few seconds (+/- 10 seconds). This is unrealistic fast and i don't know what the problem could be. My fuel is set to 1/3 full and so is the cargo. Could anyone help me and try to figure out what I could be doing wrong?
-
- 6 replies
- 1.4k views
-
-
Hi, when i am in fsx on my computer and press alt+tab and change to my desktop I get a problem when trying to get back to fsx. I can’t go back, so please, what do I do? Thanks
-
- 2 replies
- 838 views
-
-
What is the best platform to check charts, stars, and to make flight plan? I can pay but the best would be if it was free. 🙂
-
- 7 replies
- 958 views
-
-
Hello everyone, I'm using FSX SP2, also using standard aircraft not PMDG. C/O button is not changing air speed display value into decimal point when i assign AP_MACH_HOLD to a joystick's button. i don't know why?, otherwise it's working without joystick when I armed A/T First then enable Speed Hold and finally press C/O button. Please help me how do i resolve the problem?
-
- 12 replies
- 2.3k views
-
-
My name is Philip, i have a problem with ils approach and would like some help. When I get on final and press VOR LOC nothing happens, the button doesn’t light up green when I press it, and when I press appr after, nothing happens either, I just stay at the altitude, please help.
-
- 4 replies
- 765 views
-
-
It'd be nice to be able to change the liveries on the default AI Traffic so they're that of various real life airlines. There any way to do this without majorly jacking up FSX? I'm running FSX Gold Edition.
-
- 12 replies
- 6.4k views
-
-
Good day all, Im running FSX steam, and when installing DUET display (Dual view for IPAD) and try running Flight sim, I get a error that my GRAPHICS CARD DOES NOT MEET MINIMUM REQ FOR SHADER SUPPORT, this product req Gforce 3 class or better, and FSX shuts down. is there anyway around this? Would love to use my IPAD as a moving map\FMC Running Intel i7 3.4ghz 8gb ram nvida Gforce GT320
-
- 6 replies
- 4k views
-
-
Hi all, it's been a while since I've been on the sim and am getting back in the saddle with my new gaming PC, are there any sites out there that will customize your cfg file to your computers specs? Venetubo was who I used last but they're website never loads. Any ideas? FX-6300 3.50 GHz 6-Core, GTX 1050 Ti 4GB, 8GB DDR3, 1TB HDD, 24X DVD, Wi-Fi USB, Windows 10 Pro 64-bit, White (ST-ARCH-GTX1050TI-V1)
-
- 2 replies
- 1k views
-
-
-
aircraft keep turning right on taxiways & I tried different remidies in fsx realism and joystick calibration. bought logitech joystick (f310) 2 days ago and i'm at a lost at what is causing this. very frustrating as i'm an fairly adept at the silly things that can happen....have autorudder and everything else on easy mode checked joystick in control setup appreciate any help
-
- 1 reply
- 776 views
-
-
Hello all, I'm hurting here. while in my virtual cockpit mode, the engine sounds of ai traffic when they are within the area is ridiculously loud to the point it drowns out my virtual cockpit sounds. This noise level isnt the same once I leave the virtual cockpit. When looking around, the only suggestion was to adjust the environment volume slider but that didnt help. Does anyone have or know a fix for this? Thanks in advance
-
- 0 replies
- 717 views
-
-
I have noticed when I fly across long bodies of water and have ASN on there is a CTD at some point which can be very frustrating when I’m trying to cross the pond. If I don’t use ASN I have no CTD over the water. Any ideas?
-
- 2 replies
- 674 views
-
-
I have used V3for years and never bothered to upgrade since I only use it for the camera options and not weather. I just purchased P3DV4, and started the OPUS Camera app and low and behold it works! Is there any harm in using this older version in P3DV4?
-
- 4 replies
- 1.1k views
-
-
-
I recently did a clean install of FSX Gold and made the necessary tweaks to the fsx.cfg file as recommended. I've started testing the install with a DC3 Airways DC-3. Shortly after starting the flight, I seem to loose control of the flight. Even with the autopilot on, the flight path starts to drift. After about 5 minutes, the aircraft become uncontrollable. My previous setup was rock solid. I sure like some advice on where to look for my current problem. My other option is to dump a weeks of work and tweaks and opt for FSX-SE (which was recommended by others in this forum before I reinstalled FSX). Thanks in advance, Jim Driskell
-
- 2 replies
- 770 views
-
-
Hi guys, I have recently bought Majestic Dash 8 Q400 version PRO. I have a problem with night lightning. I post screenshots of my problem. Is there any way to solve it? This problem relates only to MJC Dash 8 Q400 and i do not have this problem with PMDG737. Thanks in advance :) .
-
- 3 replies
- 855 views
-
-
Ran some testing this afternoon, figure I'd share my results. The Concorde is a pig. Testing: Only thing that changed were the planes. Simple looking out the cockpit window sitting at Gate G14 at a loaded Miami City X KMIA with high FSX settings.
-
- 10 replies
- 3k views
-
-
Is there an easy way, I can find a list of the fsx airports by country (with RWY information). Preferably in a CSV format, so that I can work with the data in an excell sheet)? Thanks
-
- 3 replies
- 1.2k views
-
-
I don't understand what I'm doing wrong. I fly into an airport that is supposed to have PAPI lights, but they are not apparent when I'm landing. What could be the problem? I gone through everything that I know, so I'm hoping that some one can answer this puzzling question. thanks mikeatsr
-
- 1 reply
- 726 views
-
-
What's the best flight planning tool for FSX? I'm especially wondering which has the best fuel prediction, specifically between TOPCAT and SimBrief. Which one of the two is more accurate in determining fuel amounts and reserve fuel?
-
- 11 replies
- 1.9k views
-
-
When I fire up the sim I see the normal window, but then there's a pop up right above it that reads; " You'll need a new app to open this MsGamingoverlay. " Below this message there's a box to click and next to it reads; " Always use this app. " The Generating Scenery Box reads; 42% and is frozen there.
-
- 3 replies
- 749 views
-