PMDG General Forum

Dear all,Post here some other messages regarding FS2002 Autogen problems when using the 737NG and write yours system configuration.Mine is :Athlon XP 1700+512 Mb RAMGeForce2 MX400 64MbThanks a lotStefano "Il Pagaia" Pirovano- Italy -

Dear PMDG Support,I thought I'd wait until after the SU1 release to see if maybe you have fixed this little problem. It does not affect the operability of the airplane in any way - it's merely a cosmetic issue that I picked up.Try this:- Make sure you are in either dawn, dusk or night conditions.- Then ensure that you have the cockpit flood lighting on (SHIFT+L)- Open up the throttle quadrant- Arm the speedbrakes: See the "daylight" version sticking out top? (in the down position)- Now move the speedbrake lever around - the daylight version stays in position. Try and arm the speedbrake lever again and also disarm it - see what it's doing?I have attached a picture to sho…

I have an issue when ever I taxi in and shut down the engines, running off of the APU. Every time, afer a minute or so everything goes dark as if the battery master is shut off (which I'm not) but the APU is still running and on the bus. There's voltage showing on the APU, but everything is dark, and I cannot figure how to turn it back on.IIRC, the displays are on the standby bus, so that might be where the issue is, but I do not know at this time.Tim

For some reason, a couple of airports, Washington National (KDCA) and Austin-Begstrom (KAUS) do not have any runways in the DEP/APP page. Iv downloaded the latest data from navdata.at

How many liveries can be added to the aircraft.cfg in FS2002?TIA

Hi PMDGI just wanted to say thank you for such a lovely add-on. I simply have been waiting for a NG737 for a long time now. The visual model is simply superb. I have to admit that I haven't spent so much time in the cockpit which I have to say looks great in both virtual and 2d mode but my framerates drops abysmally in both, oh well. I have to admit that I don't have anything close to a decent machine anymore and it will be a while before I upgrade. But any tips and hint would be most welcome in how to get those framerates up even if I only use the 2d cockpit. I have been searching and looking for all the tweaks and tips that I could get my hands on to get the framrates u…

Hi All, Can anyone recommend me what settings to use for a CH Yoke Pro and Pedals (both USB). After completing pre-flight I set the trim as indicated in the FMC, but on take-off the airplane seems to pitch up rather steeply, sometimes in excess of 20 degrees. I assume this may have something to do with my joystick settings. Also, I am not able to taxi at idle after having applied more power to get moving.Any help is appreciated :-waveBoaz

Enjoy guys!!! will be at Avsim tonight.http://forums.avsim.net/user_files/29049.jpg Gary Hayes http://members.cox.net/gary_posky/siggy.gif

I`m having two weird problems in FS2004: Just had to break off a nice VNAV flight again. All I did was using the keyboard for looking out the left window! Pressed SHIFT+NUM7, then released SHIFT in order to make the view stay. And the plane starts bobbing up and down heavily, with all kinds of alarms and warnings coming from the cocpit. If I use my joystck to glance around, everything is smooth. The worst thing about this is the coffee I spill onto my :-hah every time!Tried to disconnectreconnect AP, I even centered all the moving surfaces to no avail. I went down, fast, gave up. Also the latest version of FSUIPC (3.4), didn`t help. I`m blank....The other weird thing: Wit…

Found in 737-700 southwest classic livery with first class ( didn't test in others but I belive is a model problem not a texture one) in FS2002 (not tested in my fs09) upon using remover ad doing a complete reinstall.... Afer this reinstall my FPS and thus the somoothness fell down a lot! I was able to see 20 fps locked in virtualcabinEdit:Forgot to signJos

hi all,i can not get the FMC to work correctly. i have d/l and installed the fmc database from www.navdata.atthe installation went fine and i get data in the fmc. BUT, it is erroneous (offset locations of airports, navaids, etc.).when reading previous posts i found out about the point/comma problem so i changed my system to US keyboard but this shows no success (check screenshot taskbar).on the attached screenshot you can see the following setup:location: KDAL rwy 13R (take a look at the ND, it shows me way off although the FMC has the correct coordinates)flight plan entered: KDAL to KTYR, distance less than 100 NM. problem here is that the first and last fix are shown ri…

Chaps, it seems that the only ones that suffer from this rudder deflection are the -700s without winglets in FS2004. To solve the problem, delete the "AS" from the model=AS in the config file, all works fine now if you do not mind having no airstairs. I have checked them all. Still it would be nice if we did not have to do this though. Am sure PMDG will solve it. Thanks again PMDG Awesome airplane!!

I was wondering if anyone from the PMDG team has read this thread and if so, how does it affect PMDG if at all in regards to FS9?http://forums.avsim.net/dcboard.php?az=sho...id=132054&page=

Hi There,In preparation of my purchase, I'm wondering if anyone can offer a comparison in frame rates to other payware aircraft?How, for example, does the PMDG 737 compare to the PSS Dash 8 or Captain Sim's 727?If anyone can provide me with a response to these I'd be very greatful as I already own the two above mentioned planes. These currently perform well but push my PC to it's limit. I do however have more RAM ordered to boost performance.Thank you and regards,Sean Lester

Hi Gang,Couple of quick observations :1. After T.O and engaging AP in HDG sel, the a/c tends to overshoot the HDG by almost 10-15 degress. Eg: I take off on RWY 07, climb to 1000', AP engaged, turn HDG knob left to 250, the a/c rolls out of the bank at 240 or even 235 degrees, and then comes back. The rate of bank is also very slow. But maybe this is correct, not too sure. I have the bank angle selector at 30 deg.2. When extending the flaps they "race" to 5 and then slow down the speed as you extend further flaps. I am given to understand that the flap extension speed works the other way ie., say from Up to 1 or 1 to 5, it takes much longer to extend than say 25 to 30 or …

The 737NG works great until I try to add one of the liveries. I "think" I'm doing everything per the instructions, but. When I add any livery, FS2004 will crash as soon as I choose any of the 737NG planes. I pick the plane, when I press "Fly". FS2004 crashes to desktop, no messages.I'm sure this old fool is doing something wrong but don't have a clue what. Any suggestions?George Stoddard

Hello PMDG!One question: how do i activate the wipers???Laszlo GulyasBudapest (LHBP), Hungary

Would someone please tell me how to get the new liveries? I've been to the download section of the WEB site, but I can't find them. The 700 liveries doesn't open and they don't appear to be anywhere else on the WEB site. There doesn't appear to be a download section for the forum.How the heck do I get them?

Good morning allSince I updated PMDG with SU1 I can not use Pos. Init. as the coordinates will not enter, the blocks where it says SET IRS POS are not there. Could anyone tell me what I should do Many thanksAndre

Guys, Just to let you know, there is new navadata available for download, dated 0308.Paul SPIM

Hy all,i've a problem with the autogen of FS2002 ONLY when using the 737NG.No problem in takeoff, but after descend, during the approach and landing phase, i cannot see any kind of autogen buildings o trees in front of me, but i correctly see the same thing on my left, right and behind.Some minutes after landing, the autogen still arrive ...I've checked the RAM of the PC (512Mb) and there are a lot of Mb free...Any idea ??Thanks a lotStefano "Il Pagaia" Pirovano- Italy -

Still no reply??? HELP? Please how am I suppose to register this product? I get nothing when i click "Extend Registration."Please someone help?Thanks!Lance [email protected]

Hihttp://forums.avsim.net/dcboard.php?az=sho...id=12689&page=3Would you please let us know what is going on with this and what your intentions might be?I have yet to see this on the ND after installing SU1.Thank YouTed

Hi,in FS9 the navdata (AIRAC0304 in folder ..fs9FMCWP ) is interpreted incorrectly by the FMC, for instance EHAM is displayed at N51

Guys,Was wondering if anyone could send me the Navdata AIRAC for 0308 as I did a hard drive reformat and now the Navdata site is shut [email protected] in advance,