Skip to content
View in the app

A better way to browse. Learn more.

The AVSIM Community

A full-screen app on your home screen with push notifications, badges and more.

To install this app on iOS and iPadOS
  1. Tap the Share icon in Safari
  2. Scroll the menu and tap Add to Home Screen.
  3. Tap Add in the top-right corner.
To install this app on Android
  1. Tap the 3-dot menu (⋮) in the top-right corner of the browser.
  2. Tap Add to Home screen or Install app.
  3. Confirm by tapping Install.

Radar Contact Support Forum

Official freeware support forum for the users of Radar Contact.
Website: www.jdtllc.com

  1. Greetings,Ok, I have an IFR plan from KLAS->KBOS with the last 3 waypoints being BUF, ALB, KBOS (yea, I should probabally re-export with it being BUF, ALB, GDM, KBOS, but anyway...)I have holding set at 10%. Co-pilot has the comms. We get east of ALB, continue our descent as directed to FL190, and arrival closes the door due to weather or whatever. So, we get told to turn 280 direct ALB when able and expect hold vectors. Fine, no biggie, off goes LNAV, dial up 280, then when we're there turn direct ALB. OK, get to ALB, keep going... and going.. about 20NM, then we're told that all's well with the world again, turn 095 until receive suitable for own nav, direct whe…

  2. Guest MatthewM
    Started by Guest MatthewM,

    I'm flying the PSS DASH8. The top picture shows default FS. Holy cow! They vectored me over thirty miles from the airport! The bottom is RC. Much nicer. But I do have a question. I'd like to fly the plan that I filed. In this case the green line. ATC begins to vector me to turn left to get me in line for the ILS RWY 8. However, I'd like to fly the plan and shoot the entire ILS procedure. If I declare the IAP to ILS RWY 8, does that mean that I don't have to turn to 240 and just maintain the flight path that I filed?Thanks.-Matt

    • 5 replies
    • 951 views
  3. Guest falpaol
    Started by Guest falpaol,

    HiAfter solving some problems, finally I've reached the end of my first fly LIBP-LIMC.When in 35L approach, I was in 10000'.ATC gave a heading and new altitude of 9000. Immediately after acknowledging the descent to 9000, I am told to descend to 7000 followed immediately by the standard "xx miles from the marker, fly heading 340 intercept 25L localizer, maintain 3200 (or so) until established etc ..."What do I have to do?I receive more than two instruction together......ThanksPaolo

    • 4 replies
    • 1.1k views
  4. Guest hkro
    Started by Guest hkro,

    Waiting for FSACOF updates on PSS planes, I currently use GA and in particular the Baron. I recently made a short flight from Lyon to Marseille (180NM). Everything ran OK on departure but approaching Marseille airport, I lost ATC and Jeff evans (my copilot) was repeating "November seven zero zero roger" again and again with nothing else.... I landed manually, no ATC, nothing....I updated correctly my files to RC3.1 with all wav updates (I guess)What can be wrong?Thanks for the help.

    • 3 replies
    • 801 views
  5. Guest RWSturm
    Started by Guest RWSturm,

    I recently downloaded RC-3.1, since I have upgraded to FS-2004. When I attempt to start RC, I get the following error message:"Radar Contact Version 3.1 has encountered a problem and needs to close". I have forwarded this error to Microsoft (for whatever good that is). I tried setting the compatability to Windows 98, but I still get the error. Does anyone know what the problem is? Will I ever be able to run Radar Contact with Windows XP?Bob Sturm

    • 7 replies
    • 920 views
  6. Guest Hickup4695
    Started by Guest Hickup4695,

    Greetings, Just updated to newest video drivers for Nividia MMX 440 card and now when I open up RC3 things go all wrong. Lights on taxi way have square around them as a matter of fact all lights go weird and then my computer locks up have to reboot. So, I tried a flight without RC3 and everything was normal. No squares around any lights and no lock ups. Rebooted RC3 and then squares and lock ups. I guess the newest video drivers are not compatibale to RC3 I guess. Is that possible. Should I revert back to last drivers. Don't really know how to tweak as some call it the menu screen for the video card. Any help would be appreciated.Windows XP Home2.4 Ghz CPU1 G mem…

    • 2 replies
    • 604 views
  7. Guest Kevinden2
    Started by Guest Kevinden2,

    I have all the Necessary Files FSUPIC 3.7 When I Launch RC in FS9the aircraft Jumps straight into the air ? also on the start up menutheres no clearance delivery etc... can someone tell me whats wrong ?do I need to make an adjustment to FSUPIC ?CheersKevs

    • 2 replies
    • 634 views
  8. Guest
    Started by Guest,

    Please, may you give me some information about the differences of the 4 start modalities in RCV3?Thanks

    • 1 reply
    • 599 views
  9. Just a quickie question while I'm waiting for my RCv3 order to get here...I was thinking about buying an AI traffic program, MyTraffic or something similar. Will RC handle the radio calls to MyTraffic AI traffic properly, or does it only work with internal FS AI traffic?

    • 4 replies
    • 814 views
  10. Guest falpaol
    Started by Guest falpaol,

    HiI've FS2002 Pro+ Avdisp 2.11+ RC 3.01 realtime + FS Nav 4.6 + FSUIPC 2.975+ A320 PSS+ FSMeteo 6.3I can't complete my flights.1) In the gate always listen to the ATIS (option 1)crashes FS.2) In Avdisp display the informations follows joined without clear the previous. I've set text shown.2) ILS approach crashes FSSo my RC is unusable.Please help me..........Thanks Paolo

    • 5 replies
    • 736 views
  11. Started by KennyG,

    Hi AllJust a quick question when using Active Sky with 3.1 and tuning to 122.0 to get the updated weather I find the speech is very slow from Active weather and hard to hear.Is there anyway that the speech can be processed quicker and volume turned up. I have my speaker tuned up to the highest setting.Tks for any assistance.Kenny G.

    • 2 replies
    • 677 views
  12. Started by SAS263,

    Hi all.I installed RC3.1 (?), build 2205 for use with FS9 and did a test flight yesterday. Everything went fine apart from a total lack of ATC voice during the approach part. That turned out to be due to the fact that I had copied the content of one of the Winwood folders to the wrong place (I think it was folder 10). I haven

    • 3 replies
    • 826 views
  13. Guest klucznik
    Started by Guest klucznik,

    Hello Folks, I registered V3.05 of FSUIPC a week or so ago and later updated it to V3.06 with no problems. Yesterday I had to re-install FS2004 and decided just to install FSUIPC v3.06. Lo-and-behold I could not register it because my key was considered invalid. I then installed v3.05 again and this time it accepted my registration key. Updating it again to v3.06 went jim-dandy. Thus I think we should keep the version of FSUIPC we registered in case we need a naked installation again. Just MHO.Regards

    • 0 replies
    • 682 views
  14. Guest klucznik
    Started by Guest klucznik,

    Hello Ray, As you use both Radar Contact and the PMDG 737NG I assume, due to the incompatible A/P's, that you do not use the RC CoPilot because of the need to control the aircraft from the MCP in order to follow any ATC commands, if uttered, to alter course, speed and/or altitude? Am I correct in my assumption?Thanks

    • 4 replies
    • 1.3k views
  15. Guest
    Started by Guest,

    The first - it seems that i have copied some soundfiles into the wrong library. The male co-pilots mention the various centers using a female voice... (Ruthanne i think).. Sounds rather stupid. Can it be changed easily?Secondly - seems you have to have a look at Sao Paulo (SBSP). Arriving there today in a Baron, i was told to descend to 3000 ft. Not very smart when the airport is in 2627 ft. Had to give the controller the finger all the way down or crash... LOL (Boy - he can go on nagging)... ;)Then there actually is one thing more. Think i did mention having a sound problem. Now, i do have the latest the drivers for my Nvidia sound card, but often the sound (espcially …

    • 10 replies
    • 1.1k views
  16. Started by rpowers,

    Just received FS9 (been doing outside activities now ready for my winter hobby).Can someone please give me step by step what I need to do to get RC 3.01 running in FS9?Thanks,Ron

    • 7 replies
    • 841 views
  17. Started by jd,

    http://forums.avsim.net/user_files/35508.jpghttp://forums.avsim.net/user_files/35509.jpghttp://forums.avsim.net/user_files/35510.jpghttp://forums.avsim.net/user_files/35511.jpg

    • 0 replies
    • 585 views
  18. Started by jd,

    http://forums.avsim.net/user_files/35504.jpghttp://forums.avsim.net/user_files/35505.jpghttp://forums.avsim.net/user_files/35506.jpghttp://forums.avsim.net/user_files/35507.jpg

    • 0 replies
    • 601 views
  19. Started by jd,

    http://forums.avsim.net/user_files/35499.jpghttp://forums.avsim.net/user_files/35500.jpghttp://forums.avsim.net/user_files/35501.jpg

    • 0 replies
    • 582 views
  20. Started by jd,

    taken in a delta crj200 on exhibit at the great georgia airshowhttp://forums.avsim.net/user_files/35484.jpg

    • 0 replies
    • 639 views
  21. Guest
    Started by Guest,

    Hi Has anyone had a problem with fs Navigator trying to register your registration code, I purchase fsnavigator from Sim Market.com back in 01/10/02 and was using the program without a problem, I recently purchase a new computer and had download and installed the new version 451, after using it for 20 sessions,I lost the program.I contacted Sim Market,but I still cannot get fs navigator back onI am having aproblem trying to get any help from Sim Market,not like Radar contact.I tried to re register using my old registration number but will not take.I just wanted to know if anyone elsae was having a problem like this,if I have to pay another $35.00 they can have it.if anyon…

    • 3 replies
    • 839 views
  22. Guest dan sara
    Started by Guest dan sara,

    hi viewers., just wanted to know if radar contact works ok with FDC? (i use fs04 on a 1.4ghz athlon processor)thanks for any commentsdan (newcomer)

    • 2 replies
    • 661 views
  23. Guest Figo
    Started by Guest Figo,

    I have downloaded all the necessary rc files and the fsuipc and advdisp. However, I don't get any message (normally the 1st wp) in the adventure text display in fs9. RC tells me that it is running. I did get a message saying that fsuipc was not registered- though. Can someone help? Thanks!

    • 3 replies
    • 716 views
  24. Guest rici
    Started by Guest rici,

    hello! Does anyone know were I can find more chatter for RC? I searched the library here but could not find anything, most likley my fault.Also which folder is the chatter for the oceanic stuff kept in? I can't find it.Thanks.

    • 2 replies
    • 697 views
  25. Guest
    Started by Guest,

    I think i saw this answered somewhere, now can't find it. Turned off the atc voice in fscof to rely on rc's, but i still get a second voice in the background. RC3's KEWL!

    • 1 reply
    • 722 views

Account

Navigation

Search

Search

Configure browser push notifications

Chrome (Android)
  1. Tap the lock icon next to the address bar.
  2. Tap Permissions → Notifications.
  3. Adjust your preference.
Chrome (Desktop)
  1. Click the padlock icon in the address bar.
  2. Select Site settings.
  3. Find Notifications and adjust your preference.