The FS2004 (FS9) Forum

HiWondered if anybody knew of any good scenery for VCBI Colombo and Kuala Lumpur, seen a few on avsim but they seem quite basic.Thanks in advance.

Hey All- looking for a download of FSNavigator for FS9. I have my key, but had to restore my machine and lost the program. Anyone have it?Thanks,PilotBrett11

Hi guys.I have one question regarding FS9 Tropical Sim Brazilian Airports.http://secure.simmarket.com/tropicalsim-brazil-full-pack.phtmlI could not find info is it for example Congonhas from this pack same as Congonhas X from this linkhttp://secure.simmarket.com/tropicalsim-so-paulo-congonhas-x-generation-%28en_2743%29.phtmlI tried to post on Tropicalsim forum, but my registration still is not approved.ThanksEdin

HI everyone ，The ssw310 is a great airplane in FSI like it . Can anyone tell me ，When I am ready to go ，how to engage the A/T where is the TO/GA trigger. I can not found it. thx

Good evening everyone,Im having a little issue with fsuipc's axis assignment and was wondering if anyone has run into the same problem. I am also going to try and explain it as best as I can as this is the only obstacle keeping me from flying my sim at the moment and would like to get it solved, so here goes:a little info, Im using saitek throttle control, and trying to use it with the IFly 737.I am trying to get throtle 1 to be used with engine 1, and throttle 2 to be used for engine 2.I can get the 2 throttle controles to control the throttles in the sim, but the problem is when i add throttle say 25% for example, the sims throttle goes to 25% but after about 3 - 5 sec…

I'm thinking of REX EXCLUDING the weather engine. Both REX and GE Pro, as I understand, enhance ground features. Does one have advantages over the other? Can they co-exist and complement each other?TIA

Just had an email from Carenado. "Yes, we will. Don

http://www.pairbus.com/board/viewtopic.php?f=2&t=713&start=160

I run REX for weather graphics and AS6.5 for the weather machine--I noticed that when I don't click on FSUIPC weather settings off in the FSUIPC module (from the alt menu in FS9) I get FSUIPC vis settings etc overlaid on REX. For example, with absolute blue set as the REX sky color and after loading the REX theme, when I enter FS9 and DONT click on FSUIPC weather settings off, I get a very washed out/dull sky color. I always thought you just had to click on FSUIPC weather settings off once and that was it. I also click FSUIPC weather settings off in AS6.5. Is there a way to permanently disable FSUIPC weather settings?ThanksRich Perry

Tried using FS Metar today. I get a "metar downloads failed" message.It's been working well for years right up to a couple of days ago.Anyone else have this problem please?

Hi All,I have never had this problem since I fly with FS9 but since a few weeks I had a error that tells me that dlgalert.bmp could NOT be loaded and crashes FS9.I know we are allready flying FSX but I am still stocked to FS9 would very very happy if someone out there that could tell what the problem is here.I have searche the internet and many forums but did NOT find the answer to my problems.PLEASE I would be very happy if anybody gives me the answer.Be sure I have tryd anything{reinstall and so on}Running on XP withATI 4870 Radeon graphics4 gig memoryThanks on advanceGeert [email protected]

Hi everyone!Being new to this forum, please excuse me if this topic has been done before. I could not find any details about this idea which I have. May be some memebers can help me.Can one design a system for FS9 / FSX such that several PC's on a small home network can handle scenery files, AI traffic, and so on? In a way I'd like to gather tools and utilities that will allow me to do parallel processing so that I can hook up 3-4 PC and have them work in tandem to handle for example the main view, side views, cockpits.I have used multi monitors with both FS9 and FSX (up to 3 displays) but the bandwidth is limited. Not sure if FS9 can be persuaded to run in distributed m…

Hi all.I noticed today that the nose wheel is a few inches off the ground after parking. Can anyone tell me what numbers need to be changed to correct the problem please? Thanks in advance................................John (Avid twin turbo pilot)PS: Picture provided.[contact_points]static_pitch = 0static_cg_height = 5.1max_number_of_points = 7point.0 = 1, 11.8354, 0, -5.3, 9000, 0, 0.8, 36.6, 0.25, 2.5, 0.99, 7.5, 6.5, 0, 182.16, 201.52point.1 = 1, -1.3, -7.2, -5.35, 2500, 1, 0.9, 0, 0.35, 2.5, 0.99, 7.5, 7.5, 2, 182.16, 201.52point.2 = 1, -1.3, 7.2, -5.35, 2500, 2, 0.9, 0, 0.35, 2.5, 0.99, 7.5, 7.7, 3, 182.16, 201.52point.3 = 2, 0.06, -24.5, 0.4, 785, 0, 0, 0, 0, 0, …

I recently added a airport scenery, thinking I did not have it previously.Now I am getting a error saying something to the effect "Local scenery config error in LC # 83,,,,,,,,"I looked in my scenery config folder and noticed a difference in the line entries...as follows[Area.083]Title=German Airports 2 - LeipzigLocal=aerosoft\EDDP_2008Active=TRUELayer=58Required=FALSERemote= My question being the "Remote" entry is not required...correct? And I should be able to remove it and take care of the error message.Thanks,Neil-irish3

Is it possible in FS9 to zoom below 0.31 - it is a problem when you're are using 3 monitors that fs9 has a lower limit of 0.31 - so is it possible somehow? Or maybe in a way by changing the panel.cfg of the particular aircraft?

I have a few problems regarding my wilco a320 and 7371. In the a320, I would engage autopilot about 1500-3000 agl, but it refuses to engage.2. The ailerons on the a320 refuse to work after takeoff. They worked perfectly on the ground. I've tried joystick and keyboard, but ailerons won't budge. Elevators and rudder still work in the air.3. On the 737, the plane sometimes overreacts with the controls, mostly the bank. During a turn the plane will continue banking until it's inverted. I know it's not the autopilot because the flight director is telling the plane to go the other way.If anyone has a fix, please inform me.Thanks in advance,Darryl Baniaga

Hi all,I posted the same question yesterday but I can not find the post anywhere (???) so iam posting again!Iam looking for virtual cockpits as many i can find really but especially for md-83! i did a search in the file library but no luck!can anyone point me to the right direction?Thanks in advance!

I just had an interesting situation occur and I am hoping someone else has had a similiar experence and has resolved this issue. I downloaded and ran QLRP4UT.exe. The installer placed the "QLRP4UT" folder in my "Addon Scenery" folder within fs9. I then started fs9 and went to settings -> scenery library. Once there, I clicked on "add area" and navigated to the "addon scenery" folder. I double-clicked the "addon scenery" folder to open it and then I selected the "QLRP4UT" folder. At this time I see the following: the "directory" box contains the full directory path to the "QLRP4UT" folder (C:\Program Files(x86)\Microsoft Games\Flight Simulator 9\Addon scenery\QLRP…

Any way to convert FSX flightplans to FS9 flightplans?

Wow! Thanks to Max Kraus for doing this one for FS9. :( In the Library here if your looking for it :(

I'm trying to merge POSKY's UPS 767-300 with my Level D panel but a few things apparently are not working like when engaging the autothrottles on EPR/N1 Mode for takeoff the system will not apply takeoff power.Thanks in advanceJahil

Hi guys.At the moment I'm rebuilding my PC because of hardware failure.FS9 with all payware a/c installed at the moment.Now is tricky part. Scenery installation.I'm thinking about scenerys. Is it wort it to buy Aerosoft Real Germany 1,2,3.?I have few German Airports.And could I expect some problems with this scenerys regarding OOM.Also, what is the correct order of instaling. Should I instal FS Global first and then scenerys or...?ThanksEdin

Hi,I really enjoy flying the Posky A340 cause it's accurate, great looking and very FPS friendly. But the on the other side, Wilco/Feelthere's Panel is far the best and most realistic one available. So I want to merge the two ones - the POSKY model and the Wilco panel.Yes, I know how it is done normally. Simply alias the panel in the POSKY folder to the Wilco Panel. That works well. But the problem here is: The Wilco panel is very special and fits perfectly with the flight dynamics of their model. So, for example, I can't hold speed properly cause the Posky Engines behave different, and all this autotrim doesn't really work that good...So, how can I ultimately del…

If you have ever flew the LEVEL D 763, you would of noticed that you can activate the logo lights. In real life you can activate the logo lights. So on add ons such as CS PMDG WILCO, on the lights panel there are logo light switches. BUT WHY DONT THEY WORK!?:( They just stay on all the time no matter if the switch is on/off. Can anyone tell me if i can modify in the CFG to make a logo light and switch to operate on/off? Secondly, can anyone tell me if i can make a keyboard shortcut wich could switch the cabin lights on/off Cheers, Tom Wowk (1084223)