B1900D HD Series FSX | P3D

I apologise if this has been asked before. But I am using the new B1900D in P3D, and when the autopilot is in Nav mode especially thru the FMS the altitude oscillates between +/- 500ft at selected cruise altitude. To cure this, I have to go to HDG mode and the oscillation ceases. Has anyone else experienced this and found a cure?

Hi, I'm wondering if anyone have any success with any copilot program that'll work with the 1900. Most of the big-name ones do not have the 1900 listed as compatible, at least yet. Vincent

I love their planes but documentation must have blown out the window on delivery! Does anyone know if and how to open cargo doors, wheel chocks, engine covers and the like? I think the developers are so busy making these fine aircraft, that by the time they are done, they mischeviously leave out these details and are snickering to themselves! Just kidding of coarse

The Prop Rpm gauge has two red zones. One red zone has green zones on either side. What warnings are the two red zones indicating?

For FSBuild I am using Kurt Kalbfleisch's Beachcraft B200 / PT6A-42 ( http://fsbuild.com/aircraft_performance.html ). It has PRF and TLD files. Then I modified an aircraft file for it with Carenados weights. I found this on the FSBuild forum (search): [beech King Air B200 w/PT6A-42] -- (Kurt Kalbfleisch) --- WeightUnit=LBS OperEmptyWeight=8317 PayloadWeight=1020 ReserveFuel=:45 AlternateFuel= HoldFuel= ExtraFuel= TaxiFuel=120 ApproachFuel=75 MaxTakeoffWeight=12500 MaxZeroFuelWeight=11000 MaxLandingWeight=12500 MaxFuelWeight=3645 ImageFile= PerformanceData=BE20.PRF ToldData=BE20.TLD For my testing with B1900D I changed some values to this: I added the section below to…

What settings for approach power / rpm setting to get slowed up? I have a hard time getting slow .. like to 130 then gear down then full flaps.

Anyone got it yet? Any good? How are frames? What's the FMS like? Thanks, jake

Took her up for another test run, recently and this is just a few more observations. Remember It was a while ago since I flew the real thing, but its all straight out of the flight manual and other gouge, Plus now I seem to have a little added pressure, real, or imagined, as now there are a few real world "D" drivers with piqued interests it seems. So don't read into it all too much. But if the few snags of note could be looked at and rectified perhaps, Then this could end up, being up there close to Majestics work. Which I think really set the benchmark for turboprops in the FSX/P3D world. Air Test Two, 07:30 local time Flight; Darwin(YPDN)Aus…

Carenado B1900D running win7 64 has fatal error on fsx exit only after successful flight. Fax than restarts.I can then exit fsx successfully. This only started with the B1900. I have done a reinstall to no avail. Any suggestions? Otherwise it's a beautiful bird!

Hello all, when I fly through the clouds, I have in the outside view this problem. Any idea what it is? Have the same problem with other Carenado planes too! Think any Night light textures don't like the new weather effect from ASN, at day it's looks perfect for me. Thank's for help or any suggestions !! Greetings from EDDK Markus

Hello, I'd like to have a repaint of Air Labrador. Unfortunately, i don't have any picture of this aircraft but a quick search with google and you 'll get plenty pictures. (the blue one) Thank you very much and best regards.

Hello All ---- wondering if there is a write-up or info somewhere on the FMS functionality?? Per Carenado page, FMS or GNS is a choice that must be made...one or the other. Comments on the FMS functionality appreciated. Thanks --- Bob --- :wink2:

Anyone else have this issue in P3DV2? Rob

Hello, I love the new B1900D. It's a beautiful aircraft and now, for the first time, I hesitate to install RXP since I like the new FMS. I am having a problem setting my individual throttles (1&2) through FSUIPC. Both throttles will move if I set one throttle lever to just "Throttles", but if I try to set the individual Throttles to different levers, only Throttle #1 will move. Is there something that I'm doing wrong? Thank you, Bob

Has anyone tried to modify aircraft.cfg with a string that will work for 3D lights from A2A. Carenado A/C have a little different system for lights. I eant to do something because the NAV lights and other lights are so dim.

Is anyone else experiencing uncontrolled pitch-up movement on takeoff where even pushing the yoke in all the ways and trimming the nose down as far as the trim wheel will allow won't reduce the ascent angle to anything less than 10 degrees up? All my other aircraft behave properly - it's just the B1900D that's affected. I'm stumped. Beautiful plane but with this issue it's currently unflyable for me. I'd appreciate any suggestions you might have on getting around this difficulty.

Hey guys!! Just got the 1900 and was trying to set up my EZDok but when I try to set the Aircraft views, It shows the skeleton of the plane and the red annotation in the upper right corner of sim says im still in VC.. All VC views are set and work properly but when I try to go outside to do my walk around, I dont have the external graphics... Just 1 wheel and half the plane with no skin.... I loaded another operational aircraft and the external views work fine and the red annotation says EZDok Aircraft Universal View.. Anyone else having an issue like this? Ive tried loading other saved CAM sets but I still get the same skeleton view when I switch views. Also whe…

Hey fellow simmers! I just bought this plane yesterday and I have to say that this Carenado's best product ever. I have one issue, I ran the installer for the RXP530, and when I got inside the plane it does not turn on. Any ideas why this could be? Thanks

Hey Guys Just brought the aircraft today, about to start a night time test flight, but for some reason all interior lights will not turn on. i.e. the shift + L or L command will result a quick 0.2 second flash of VC light then everything is dark again; if I try to use the individual light switch on the overhead panel nothing happens My first Carenado product :( Cheers

Will it do the various RealityXP Garmin approaches LPV etc? Does the RealityXP Garmin drive the HSI .. display / glideslope ?

I have been looking forward to this release for a long time, and I am very excited to finally get it installed! The B1900 is one of my favorite planes, and it is about time a replacement came along for the old PMDG model. I was wondering if anyone who owns the plane would be interested in creating some liveries for the aircraft? Thank you very much in advance! These are the ones I'm looking for: Midwest Connect Great Lakes Airlines Continental Connection

Anyone has speed cards for this aircraft. Best regards

Hi I have problem for my Carenado B1900D P3D V2, the landing gear no retract and the flaps no function. Problem P3D V2 or Carenado Have you this problem ? Thank.

I thought we would get the liveries of Air Canada, Air New Zealand etc as seen in the development period pictures. Are these accessible somewhere ?

Hi, instantly after I bought the 1900D directly from the Carenado website I received another email (that was blocked because of the attachment...) saying: "Dear customer, we have noted that the “RXP530.exe” file included in your recently purchased Carenado B1900D HD Series FSX/P3D is not working properly impeding to use the Reality XP GNS530. Attached is a patch which correct that issue. Unzip it and double click in the installer which will correct that file." The file attached is called "1900D_SPRXP.exe". Is this a trustworthy Carenado mail or just a bad joke? I won't execute the patch until I officially hear from Carenado that my computer won't get infe…