vonmar

MSFS2020-Longitude-Panning-ok Quick test screenshots during Chart panning (joystick): Edit: Just to verify if you are using LOCK or Legacy in Cockpit Interactions: I use LEGACY.

You are welcome. Remove your old Navigraph cycle (your mismatch problem) to use the default MSFS data:

If your are selecting Navigraph Navdata for MSFS you get the Navdata (sub) cycle your paid for.

All ok using MSFS2020/Navigraph KHKY ILS24 SANFI transition:

Additional information. Page 18 of the Flightfx Citation X manual gives a link to their tutorial video: https://www.youtube.com/watch?v=Uer2j267z08 Speeds and altitudes that are part of the e.g., SID/STAR/APPROACH will be shown in the FMS. You can hand enter data for other user or ATC assigned speed/altitude for other route waypoints.

Great video. Great content. You are correct on all points mentioned in the video. “Flight Simulation Is Becoming Too Expensive ?” Yes. My two PC’s (5 and 6 years old and $3000 USD each) are OK for: FSX, P3D 4,5,6, XP11, Xp12, MSFS2020 all currently used for my training flights. My next PC because the current ones are old enough for the bin would be right at $5000 USD. So then when I get a new PC $5000 PC I can then Add $$$? for MSFS2024 + new aircraft, airports and add-on software for it. Currently in a holding pattern on a new PC and MSFS2024. Note: I seldom fly any of the included default MSFS2020 aircraft.

The Beechcraft Bonanza G36 does not have rudder trim.

Ok, great. You have a working Elevator trim. Do not worry about outside view. We are not flying and testing right now. It does move very slowly. Did you test Elevator and Aileron trim wheel movement with just the mouse and not Yoke buttons?

Beech G36 Aileron Trim is present and is working in MSFS (screenshot). Have you tested to see if it is moving (turning CW/CCW) on command in your setup? This is only a 30 second test prior to taxi or takeoff. Note: There is also an Elevator trim wheel. Is it turning on command in your setup? Edit: Both trims must be checked for correct setting prior to takeoff.

Did you check the MSFS's Bonanza G36 Aileron trim wheel as I previously mentioned?

I tested the Bonanza G36 aileron trim and it is working (MSFS2020). I have the trim assigned in FSUIPC and in MSFS2020 while using Saitek Yoke buttons. If you manually use the trim wheel and mouse button in the VC cockpit does the aileron trim wheel move? Edit: Mouse select CW or CCW arrow then Clicking or holding the L mouse button? In Bonanza only the Left mouse button is used on my testing. If you use your assigned yoke buttons does the trim wheel move? Clicking or holding the assigned L/R button down?

While hand flying are you correcting for roll? Which aircraft are you flying?

Thanks for confirming.

Just had the PMDG777-200LR (2.00.130) freeze up just before selecting (Perf Init) ZFW LSK. Nothing working in the VC cockpit except a few lighting knobs could be rotated. Had to exit MSFS2020 version 1.39.12.0.

This Chaseplane Update is only for MSFS2024.