The Level D 767 | Wilco PIC 767 Forum

Hi Guys, I installed the Level D 767 on my FSX SE and I find the sim to hang, stop responding for a while, then responds again and so on. I also find that when I turn on the landing or taxi lights it'll begin to hang. I use Windows 10 OS, but I'm not sure if that's the reason. Any help would be appreciated ~Asif

Hi Guys Is anyone using CPflight 737 MCP with Level-D 767. It seems to work fine with every PMDG, and Default FSX aircraft, but when I try to use the MCP with Level-D...... I receive a: Runtime error 53 message. file not found Paolo (at CPflight) has been very helpful and is trying to solve the issue, but I was wondering if anyone here has any suggestions or advice. Regards John

I have lost the Panel gauges on my 767, just blanks. CJ .

Hi Is it possible to get Level-D for FSX to Work in FSX-SE?? B.g. Steen Hoejengaard

Hey, Saw your post. I redownloaded today from FLt1 and got that damn panel iniatilization error. After a few hours, I finally got it to work. Make sure you have all the simconnects 905,242,259 and 608. Next make sure you have a simconnect cfg AND a simconnect xml inside the user/appdata/roaming/fsx folder. This is the wording, use notepad: Change the ip in the xml and cfg to match the ipv4 number in "ipconfig" you get when you run the run command.as administrator. <?xml version="1.0" encoding="Windows-1252"?> <SimBase.Document Type="SimConnect" version="1,0"> <Descr>SimConnect</Descr> <Filename>SimConnect.xml</Filename> <D…

Hi I am going to purchase the above mentioned aircraft and can have a 40% discount as I already have purchased the 2004 version. I have downloaded the FSX version and coupon. I am not clear as to going on from there. I hope someone can steer me right maybe please. Looking forward to hearing from someone.....................John

Reinstalled Level D 767 from current installer on dedicated drive in E\:FSX folder after new drive installed. Get the following error when I try to run the LD767. Worked fine until reinstall. Level D briefly starts, locks FSX, then displays message below. I've never had a problem with the LD767 not running before. Can anyone tell me what bitmap file is missing or where to look for it Thanks steve s

Hi there, I am looking for a B767 addon that does particulary well for hand flying. It needs to have an accurate/realistic flight model and accurate EPR indications for the PW engines. I dont mind it being a systems simulation at the same time, but that is not a requirement. All info I found about the B767 by level D is that it does not have EPR indication for the PW engines. The flight model is said to be very good though. I was wondering if any of the Level D updates that came out over the years ever added EPR for PW engines? Another option would be the Capt sim 767, which does have different engine options including EPR for PW if I am not mistaken…

Just did a clean install of FSX, and for the first time did not install the Level D 767. Too many other excellent planes on the HD now. It had a good run though - there has been a version of this plane on my computer since FS 2000, when the Wilco version came out. Thanks Level D. It's been fun. Colin

I just installed the 767 with UAC disabled and no Antivirus disabled. It asked me to allow several gauges so I hit the run button. As soon as I pick airport and starts the loading when it finishes I get the fatal error everytime. Anybody have any suggestions?

Hello! A couple of days ago I bought Zinertek HD VC Textures for Level-D 767. It looks great but i have a problem. When I fly the 767 I fly with the livery TUIfly Nordic. The problem is that when I choose that livery, I do not have the HD textures in the cockpit. But If i choose the main Level-D-livery I do have the HD textures. Is there any textures Zinertek HD textures I have to replace in the TUIfly Nordic livery-folder? TUIfly Nordic Livery http://i1357.photobucket.com/albums/q748/Bjorn96/blx_zpsdqyupphi.png~original Level-D 767 main livery http://i1357.photobucket.com/albums/q748/Bjorn96/BLX2_zpst9ruoohz.png~original Best regards

I just tried to have a little look at the level-d forums, but when you type the address in, the website is gone and the domain is up for sale. Anybody else noticed this?

I have done a lot of reading about getting various add-on's to work with Steam. For the most part I got the LevelD 767 to work, except when I try to enter information into the FMC. I'm unable to enter in the gross weight, the ZFW, or the T.O. trim info. For the gross weight, and the ZFW? I get a invalid entry on the note pad. When I try to enter the T.O. trim? nothing happens. All other switches, and buttons seem to work. Any idea's on what may be causing this?

for some reason, whenever I fly the plane, I lift the yoke and the aircraft pitches up, everything is correct (Trim, MTOW etc.) and for some reason the aircraft just stays on the ground. Would anyone know a fix to this? Thanks in advance, A.Shul

Hello all...I have a problem when opening the forward cargo door. When I hit Shift+E+2, the forward cargo door opens, but it then disables the throttle leaver for engine 1. It won't move at all. I looked to see through the Level D menu if the key assignment could be changed, and nothing. Hoping maybe some of you might have another idea... Thanks

Hi Level D,Can you give a rough idea on where the 757 is? The 757 isn't a must have for me or I would of gone for the CS 757 or qw 757, but im going for yours.Any update at all, even "its coming" will do :(

Evening gang, Is this add on compatible with windows 7, 64 bit? Does it work well? Any anticipated bugs? Have the fs9 version, a real dream. Thinking of getting the FSX model.

Is there a mod, or a planned upgrade, that places a working fmc in the virtual cockpit of the LevelD 767? Last time I checked you had to click on the gauge and it popped up a 2d panel.

It has been quite a while since I flew it, but when I try my LVLD_B763 in FS9 the following occurs. 1. Start FS9 with the default FS9 Baron at my home airport KMYR. 2. Select the LDS 767. 3. Loads fine with the tips screen appearing. 4. Clicking on any option has results that take forever, (e.g. FMC toggle, OH toggle, switches, etc.) For example, if I try to bring up the FMC, it make take up to two minutes, then it appears. 5. Select another aircraft, and everything is back to normal again. The only other thing that is a bit weird is that I normally choose to hide the task bar at the bottom of my screen. If I move my mouse curser to the bottom of the scre…

Here is how... Not supported by LDS but it is a simple merge and you can have the awesome Level-D panel and VC with a great new updated 767 model.

Hi, When I fly the 767, after climb, I see that my Approach page shows up when I press INIT REF. The thing is, it shows information for the approach to my departure airport and departure runway! Ex...I am flying JFK-BOS. I took off JFK 4L, and am climbing now. I selected 22L at BOS. The approach reference page shows information for the ILS 4L at JFK. What am I doing wrong? :/

for fs2002. Does anybody know how I can get the patch to install the 767 in fs 2002?db.

I have a problem that just started recently. I have the current airac 1413 for Level-d.When i taxi to the rwy and line up with the rwy, the rwy display in the EHSI is to the side.I thought that it was the current airac but when i reinstalled the 1412 same thing.Also when lining up for a ils, the rwy is right in front me all the way down to touch down , BUT in the EHSI the rwy is to the side the glideslope and localizer are are telling me i am off to the side. So trying to figure it out and experiment i found out that the SLEW button Y, lines up the rwy in my EHSI. When not in slew it puts the rwy to the side. I also found out by experimenting that if i start a flight a…

Hi,I love this a/c but I never liked the default external engine sounds so I'm looking for an alternative sound package. I noticed TSS (Turbine Sound Studios) have 3 different sound packages (one for each engine type) they say have been tested with the Level-D 767. Is there someone who have tried any of these sound packages for the FSX version of the Level-D 767 and can confirm they work and also please comment on their quality compared to the default sound.If of importance I'm running FSX SP2 on a Windows 7 x64 rig.TIA,

Hey,I had the LVD 767 for a month something like that, and i had a problem with fsx so i removed it and re installed it, and re installed LVD 767, but now i dont have any callouts, any idea, though i have all the v1 vr v2.thanks