The MILVIZ Support Forum

The gauges are supposed to be able to replace the stock Bendix stack 1:1 and so should in theory work great with the C310 FreeRadio version too. It did take some manual tweaking, because initially the radios were all stretched and didn't fit, but I figured it out (can post the panel.cfg if MilViz are OK with that?). A few shots: The frame rate is very nice. On my system, the 3D Analog version stutters a bit and is about 5-8 FPS slower than many equal addons. It drops as low as 12-13 FPS occasionally where as the FreeRadio version is always in the high teens or higher. With the FSD radios, the FPS is only about 0.5 FPS lower than the default radios. Even if…

Shockwave landing lights installed in my new Bron B-55. Note, these do not increase the amount of visible light in the light cones in front of the airplane.

OK, I'm sitting here in the left seat admiring my shiny new cockpit (looks good indeed BTW) and I have the nav lights toggle switch firmly between my sweaty fingers and I even see the nav/strobe legend below the switch, but all I get is the normal up for on (navs--no strobes) and down for off action. Am I missing something?? Did I get a bad install? I had my AV turned off but the firewall was left on. Boy, this is a nice looking airplane

In visiting the Milviz main forum I noticed a new forum called: Boeing 737-200 General Forum. It is located inside the Completed Milviz Projects area. With zero post inside it .... goodie goodie!

I am planning a purchase of the B-55 Baron within the next day of two (Milviz direct purchase). Are there any recent updates I need to know about?? Has the lighting issue been addressed?? The other issue noted in early April??

Regards

I picked up the Baron just before Xmas and am enjoying it immensely. Have to say though, I'm surprised by the lack of repaints available. I've only found the one blue retro repaint by Skyhawk. Having absolutely no repainting skills this is an unashamed plea to any repainters out there. Both my soul and my grandmother will gladly be for sale, and my gratitude undying, if anyone could come up with a British repaint for the B55 - either of these would be gladly welcomed. http://www.abpic.co.uk/photo/1242809/ http://www.abpic.co.uk/photo/1113740/

I have been struggling with poor frame rates and stutters with the C310R VC view. Where I normally have smooth 30 fps with any other aircraft, the 310 is getting high teens at best and stutters. Exterior views are fine. But, I discovered this was not so at night. The night vc is getting a steady and smooth 30 fps. In fact if I load a flight at night and then change the time to day the performance remains fine; a steady and smooth 30 fps. Any thoughts on what may be causing this behavior or perhaps a possible fix I could implement? Thanks, Jesse

Hey guys, Tomorrow at 9:30PM EST I will be streaming the 737-200. Don't miss out, as we will be making a BIG announcement regarding the project. To watch the stream, simply follow this link: http://www.twitch.tv/Military_Visualizations If you'd like to interact, simply create an account at twitch (very easy process). Hope to see you all there! Regards

Hi all, We are presently considering a general "beta" release or pre-order of the MV B-732. I would like to know how many of you are interested in this type of thing and whether or not it's even a good idea. Some of our competitors do this and it seems to have worked (somewhat) in their favor (that they didn't finish isn't good but.. that's not us). We'd offer between 10 and 15% off final price and, just so you know, we will no longer be doing sales so... don't expect anything like that... So, what I would like here is... a yes or no. Yes means... DOOOOO EEEET and No means... well.. .uh.. NO! Thanks, Colin

Here is a fix (tested) for those of you who have the horrible floating square... Note, this does get rid of the lotus style landing lights. If you do not know how to navigate in the FSX directory structure DO NOT USE THIS. We will be releasing an updated installer shortly that will deal with all this. Though this is good ONLY for the B-55/E55 we do intend to look at the others and implement this fix across the board. www.milviz.com/filesfordownload/Beech_Baron_55_landing_light_fix.zip Thanks for your patience.

I noticed an update to the B55 on the Avsim front page. I installed it, and am now getting an error message " failed to open the flight model" when I try to run the aircraft. Does anyone have a better experience?

Just getting around to finally setting up the avionics as I want - and in the free radio panel, the right hand knob from the 3d GNS430 is showing up. I haven't seen any other posts with this issue, which is odd. My version is MilViz_B55_v5.120830. I really want to use the free radio panel, since I only own a single RXP unit and would prefer to set that up in the same manner as my F33A.

In preparation for the all new Milviz P-38J Lightning, we are proud to announce the re-release of an old classic, the Milviz P-38J/L "Red Bull" Redux. With updated flight dynamics, modified external and internal models/textures, we are sure you'll have an amazing time zipping by your competition at Reno Air races. To Purchase, follow this link: http://milviz.com/fs/item.php?id=P-38RB All the best!

HI all, I'm new to the Sabre and bought it just a few days ago. I have a few difficoulties tuning the ADF. Let's explain this with an example: I want to fly to EDDG, Münster Osnabrück airport, so I try to tune 371 in the ADF. Now as it's difficould to see the exact frequency I go to 370 and then play around a little. But I never get any indication on the instrument... Same problems at other NDBs, so it shouldn't be a general problem with my FSX, expecially because the NDBs are working with aircrafts with a pecise tuner. Am I doing something wrong, or is there any more precise method to set the ADF? Thanks for the help in advance.

http://www.milviz.com/forum/viewtopic.php?f=3&t=2660

Hey guys, Just got these images of the new F-15C cockpit: All the best

Hi Guys. Having trouble trying to install my Rxp 530 into my B55. I have tried using some suggestions I have found on the Mil Viz site but am a bit lost. I have installed it into 2 of my Carenado planes. I am not sure if my RXP.ini file is right. If anyone has had some luck with this could you please post your Panel file and your .ini file as well. Many thanks Brett.

This one has been flying under the radar: http://dl.dropbox.com/u/20842697/f100D/f100d_vc.html Please keep in mind it is a Work In Progress. All the best

Hey guys, I have created a LiveStream for Milviz, and will be streaming tonight at 8:50PM EST: http://www.livestream.com/Milviz Tonight, I will be continuing Beta Testing on the 737-200. Hope to see you all there!

I just installed the Milviz F15E yesterday and am having a problem. It loads OK and other planes fly and behave well. I purchased it right before Christmas so I think it's the latest version. When I tried to fly the Eagle only a few of the cockpit switches functioned. I've flown it before on another computer before moving it to this one and it worked fine. I used to start the engines by using all the proper switches, JFS, throttle locks etc. and it worked great. But yesterday only one switch would function. Control E would get the engines starting but wouldn't run. Anyone experience this? Thanks.

Anyone have a solution for flying with another sim online? I guess game spy is no longer available. Thanks.

Thought I would share some images of the Milviz Bell 407 WIP: http://milviz.com/forum/viewtopic.php?f=3&t=2478 All the best!

Hi Guys, I've been considering your 737, it's looking very nice, can't wait to see how it turns out! A couple of things I wanted to know: 1. The facebook page mentions it could be multi-crew capable - does this mean we'll be able to actually fly it multiplayer with two human players type multicrew? or do you mean some kind of voice control? 2. Will there be the ability for hardware to interface with it, either FSUIPC mouse macros, Lua scripts, SDK, or anything like that? It doesn't matter how,-as long as we have A way to map our hardware then someone will make the scripts. Many people got stuck buying other classic jets like the 707 and 727 that were developed in su…

Just wanted to say Thanks for doing this aircraft. I know some folks that own MU-2's, so if oyu need conncections; I'll try to help. Best, David