Hi all, I’ve posted this at FSDT forum but had no reply as yet.

The other day I was given a non-standard but very reasonable push back instruction from VATSIM ATC that I couldn’t properly comply with. 

I have today tried to learn the art of a quick edit pushback however the arrow keys don’t move the “target” but just move the camera/view around. (Or if they are moving the target it’s minimal and not usable due to the camera moving).  I’ve not, to my knowledge, changed settings for bindings and can’t see anything obvious at all. This is in FS2020.

Help?   Thanks in advance. 

Same issue here although I don't believe it's a GSX problem per se.

It is most likely a keyboard binding issue in 2020 depending on the keyboard profile you are selecting for your particular aircraft.
I'll be delving into this sometime today and hopefully find the answer.

Thanks. I’ve not done much/anything with the keyboard profile and did a test in 2024 with the same issue.  I thought perhaps I’d missed a setup step for GSX but can’t find anything. 

It's definately a keybind issue. Just look the commands up in the menu and then change the keybind accordingly.

12 minutes ago, Farlis said:

It's definately a keybind issue. Just look the commands up in the menu and then change the keybind accordingly.

I did a search on the keyboard by “control” and the arrow keys didn’t trigger anything….which was helpful!! I’ll keep looking. 

Just now, ianb2469 said:

I did a search on the keyboard by “control” and the arrow keys didn’t trigger anything….which was helpful!! I’ll keep looking. 

I mistyped. I meant manual not menu. All commands that GSX uses are listed in there.