navyman51

Hi All, there does not appear to be a official TDS forum but here goes. I have down loaded and installed the "Blank" a/c into FS9 and with the panel the a/c flies fine. The trouble came when I tried to install a KLM B737-800 texture. Not matter what I've tried I cannot get the texture to show in the a/c list. I'm missing some fundemental instruction. Is there anybody out there who could help me with this. Thanks in Anticipation navyman

Hi All, I have fixed the pronlem. I selected the RealTek Digital device and made a the main communication device. That cleared the problem. Hopefully I can now begin flying. navyman51

Hello, I have done a fresh install of W7/FS9/RC4.3. I have a problem with sound. RC loads as normal and everything looks OK. When I select the Voices TAB and try any of the voices I hear nothing. I use the on-board sound card which seems to play music i.e. installed sample files. When I run FS9 my default flight is Cessna I can start up the engine and hear the engine running. When I select a ATC option i.e Taxi to Runway, I also hear no speech. I have checked what settings I can in the RealTek HD Audio Manager without success. I notice when I open up the loudspeaker icon on the Task Bar in Mixer that FS9 appears there but not RC. This is the first time of using W7. I do run from the RC icon as administrator. Any ideas would be appreciated. Thanks in advance navyman51

Hello, sent for a key request on 8th Dec. Nothing yet. Please help navyman51

Hi Ronzie, Thanks for the info. navyman

Hi All, This might seem a newbie question. I am about to install FS9 onto a SSD with WIN7 This drive will be drive C:\ The SSD is not very large, and I would like to install all my scenery files to a different disk drive, this drive will be D:\. I know that FS9 can cope with that. My question is can I direct RC to find the scenery files on D:\ when building the scenery data base? Also can I install RC on the D:| as well. Thank you. navyman

Hi Ronzie, I found a fix for this problem from a previous fix posted by you re London City airport.I applied the fix for LOWG and it worked. I down-loaded makerways 4.51 and updated FSUIPCand it solved the problem. I did check av4 and there was LOWG, now there is.Many thanks for fix.Regardsnavyman51

Hi JD,I have a problem with RC recognising one particular airport ICAO. I have a flight plan generated by FSNav which starts the flight at LOWG (GRAZ) and terminates at LIRN. I load the fp into RC but the fp window does not show the start airport ICAO.I have tried other Austrian airports as I regulary fly from LOWS with no problem. I tried rebuilding the scenery data base and I have looked at the fp which I saved in FS2004 and I have compared the information in the LOWG plan to say LOWS and the FS2004 plan has all the correct information relating to LOWG.Can you please helpBest Regardsnavyman

Hello Guys,Thanks for the replies, I'll start looking.navyman

Hello Team,I am looking to replace my ageing AMD 2200+ system with a modern up to date system.It will only be required to run FS9. Can you guys give me a minimum spec system thatwill run FS9 smoothly with few addons. I intend to buy a off-the-shelf pc as I am notpc educated!!Many Thanksnavyman

Hi, just read this post and I find I have the same problem. If I set the cruise altitude directly in the Controller page, the next time I loada FS Planner flight plan say at a lower level RC will not read the new level and will still have the old level set. I only useFS Navigator derived plans which I then save in FS Flight Planner then load into RC.