I could not get RC3 to work with Iron knuckle DC9, but with DF B737 it worked verry good.:) I was flying from ESGG to ESSA and when I recived clearens from ground I didnt get Pushback & Start as an option just ground for taxi.What is the setting that decide if an airport offers pushback or not?Another question regarding taxi clearens, I just got "taxi to RWY 03" not a via "HZ Z A" and when taxing no "hold for traffic" when AI aircraft is crossing your path on taxiway?Regards,Johan (JD);-)

Johan,>What is the setting that decide if an airport offers >pushback or not?No option. It should just be on the menu.>Another question regarding taxi clearens, I just got "taxi >to RWY 03" not a via "HZ Z A" and when taxing no "hold for >traffic" when AI aircraft is crossing your path on taxiway?RC knows nothing about taxiways. RC knows nothing about ground traffic. These are both limitations of FS. Until MS dains to grace us with an ATC SDK there's nothing that can be done about it. There's no way RC could know what ground traffic is moving, and if it's moving anywhere near you or where it's going.

Unfortunatly, I got no PUSHBACK option in the text-window at ESGG.I have to try, a nother destination to see if its working elsewere.How do I become a proud supporter of RC3, is it by not report problems.:-lol Regards,Johan

Johan,Save me a dat (look for "Saving Dats" below), and zip them and send the zip to me. When you click "Start RC" - SAVE THERE.You can get your banner from the Flight Deck/rcv3 page, or go to the "Welcome to Radar Contact" topic at the top of the forum, and read the instructions.

Thaks for a quick awnser! :)Im unfortunally at work so I

Johan, One reason you may not be seeing the pushback option is that the advdisp box is too short! Try resizing it a little taller and see if the pushback option is showing. You should be seeing the page lines at the bottom as well..... 8 for back, 9 for forward, 0 to return to page 1 of the menu.Best, Rob

OK, I will try and re-size the advdisp, to bad I can

Johan, What problem do you have with the PSS-Dash panel? After docking AdvDisp are you right clicking on it and "saving" it? Is your panel cfg marked as "read-only" when checking it's properties?Best, Rob

My problem is that all the PSS panels are vissible and AdvDisp is empty and dont respond.I have not checked if the panel cfg is marked READ ONLY.Regards,Johan

Now my PUSHBACK problem is solved thank