April 11, 20242 yr When I use the Travel To command, I get unusual results. If I Travel To the Descent, I’m typically off course quite a bit. But then the ATC gives me a vector that takes me even further off course than I already was. Seems like the ATC should do something to place you back on the original course or something like that, I’m not a real pilot so I don’t know for sure.
April 14, 20242 yr On 4/11/2024 at 12:09 PM, goofeyfoot said: When I use the Travel To command, I get unusual results. If I Travel To the Descent, I’m typically off course quite a bit. But then the ATC gives me a vector that takes me even further off course than I already was. Seems like the ATC should do something to place you back on the original course or something like that, I’m not a real pilot so I don’t know for sure. Maybe ATC is trying to get you back to the last waypoint that was on your path before the Travel To? Try requesting a Direct To the new next waypoint based on where you end up after the Travel To.
April 14, 20242 yr Commercial Member Also, the DIrect To waypoint must be a valid published waypoint, which excludes the TOD. Dave
Archived
This topic is now archived and is closed to further replies.