Hello,

When I run P3D v4.5, the voxatc box does not appear.

After uninstallation, relocation, always the same

Voxatc is registered, no problem

I spent several hours searching, nothing to do, voxatc does not want to appear ...

vox is intiated (if you have it installed in your specific aircraft ) as a gauge panel ... so in the drop downs, look for vox & "enable".

'tis not an autoload.

 

Thanks for answer but i dont understand what you advise me

 

What do you mind about "if you...your specific aircraft" ? I use Prosim

 

"vox&enable"= do you mean about "registred" ?

Hi,

Did you launch VoxAtc Indexer program then the Panel Setup program?

If not, after installing Vox, you must launch the VoxAtc Indexer program (this takes some time since the program scans all the scenes, airports and aircraft had been installed in your system).

When this is done, you launch the Panel Setup program, once finished you must have the list of aircraft in your possession. Check all the aircraft for which you want to use VoxAtc.

Launch P3D, choose aircraft and scenery. Once your flight is loaded, go to the Vehicle menu then Instrument Panel. There you must have among other things VoxAtc, click on it and there you go....

Richard

 

 

Hi, I found, it was about getting in cockpit view. I tried everything except that